This number defines how meny times the entire queue will be reprinted.

Example: Plate "A" is set to 3 repeats, plate "B" is set to 1 repeat and the "Loop repeats" is set to 2. This will result in following printing order:

A A A B A A A B .

This setting allows you to setup a delay allowing to plate to cool down before swap. This is appropriate for large pars that tend to warp.

When this setting is activated, it will keep the last plate on the heat bed without swapping. This is reasonable when rails are used but the space is limited.

When this setting is activated, the start gcode will be modified and M970 - lines commented out in order to suppress the vibration calibration. Only the initial calibration before first plate will remain.